Many years ago we added a small porch to the front of our home with Chippendale railings. This fall we noticed that time had taken its toll on the railings and one side was falling apart due to rot.
The other side of the railing had no rot.
We removed the damaged side of the railing and began the process of building a replacement.
So that the sides would wear evenly in the future, we decided to remove the side that was not damaged and replace it as well. Our porch was without railings for several months as we built the replacements.
How to build Chippendale Railings
We purchased pressure treated 2x4s and 2x2s for the project. Since we had the old railings, we used them as templates for the new railings. 2x4s were cut to length, and cut on the table saw to the shape we wanted, with a crowned top which generally matched the original shape.
We started by framing in the railings with the end post (here on the right) and a sacrificial board on the left – whose end will eventually be fastened directly to the porch columns. The 2x2s were planed to a slightly smaller dimension so as to square the corners. The main center cross braces were cut to length and notched such that they would fit together in the center.
After the main cross braces were in place, the intermediate pieces were cut to length and the cutting angle marked on the pieces. Once marked, the angles were cut with a powered miter saw (chop saw).
After cutting, the angles were tested to verify a tight fit and were then glued into place. The top/bottom and left/right pieces were mirror images of each other, so the angles were all cut the same. It was important to have a bunch of clamps available to hold everything into place while the glue dried. Where practical, screws were later added to ensure structural integrity.
Below you can see that the top/bottom sections are identical, as are the left and right.
After both railings were built, we primed them and painted them with two coats of paint. Here, again you can see the sacrificial board (on the left) that will be removed prior to installation.
After the railings were painted, we attached them to the brick with concrete screws and to the vinyl columns with deck screws.
Removing the old railings and installing the new ones removed some of the paint from the vinyl columns. A light sanding followed by a few coats of paint fixed this problem. The screw holes were filled in and painted over as well.
Caulk in all necessary areas seals the railings to prevent future rot damage.
We both are glad to check this project off of our DIY list!
Chippendale doors and railings are very popular in our town. When I’m walking Sherman or running, I enjoy looking at the many styles of Chippendale doors in our neighborhood. A local hardware store made our Chippendale front door and Mr. SP crafted the one on our porch.
This project took a few months longer than anticipated due to working on it sporadically. The wait was worth it! I’m hoping to get some flowers planted in the pots this week.
Are Chippendale doors and railings popular in your town? My guess is it may be a southern thing!